Material Preparation
Before installing the manual oil pump, the following materials need to be prepared:
Manual oil pump body;
Oil pipe;
Filter element;
Piston;
Tools such as wrenches and screwdrivers.
Installation Steps
Installing the Oil Pipe: First, connect the oil pipe to the suction port of the manual oil pump, ensuring a good seal between the pipe and the port. When connecting the pipe, tighten it to the suction port with a wrench, but be careful not to overtighten to avoid damaging the pipe.
Installing the Filter Element: Next, install the filter element onto the filter holder of the manual oil pump. First, unscrew the filter holder, then place the filter element into the holder, and finally connect the holder to the pump.
Installing the Piston: Connect the piston to the plunger rod of the pump. First, unscrew the plunger rod, then insert the piston into the center of the rod, and finally connect the plunger rod to the pump.
Installing the Piston: When installing the piston, connect it to the plunger rod of the pump. First, unscrew the plunger rod, then insert the piston into the center of the rod, and finally connect the plunger rod to the pump. Check for Correct Installation
After installation, check that all components of the manual oil pump are correctly installed. First, ensure a good seal between the oil pipe and the suction port. Then, check that the filter element is installed correctly. Finally, check that the piston is securely connected to the plunger rod.
Precautions
When installing the manual oil pump, ensure that all components are properly tightened, neither too tight nor too loose.
When connecting the oil pipe, carefully check the seal between the oil pipe and the suction port to avoid leaks.
When installing the filter element, pay attention to its orientation; do not install it backwards.
After installation, check to ensure that all components are installed correctly and that the manual oil pump operates normally.
